433MHz RF Wireless Remote and Receiver— Hands-Free For Prop Activator Controllers

Add hands-free wireless triggering to your Prop Activator Controller. The same 433MHz RF remote that ships standard with the Actor Helper Controller — now sold as an add-on so Prop Activator owners can fire their props remotely, or replace a lost/broken remote.

🆕 New Accessory — Requested by Customers. Many of you asked for a way to add wireless triggering to the Prop Activator after purchase, or to swap the button trigger for a motion/RF trigger. This is that add-on kit: prewired receiver + remote, ready to wire in.

What This Kit Does

• Wireless trigger for your Prop Activator — fire any prop sequence remotely without running pushbutton cables across your scene.
• Replace a motion sensor or wired button — swap your existing trigger for RF, or run both in parallel.

What's in the Box

• 1× Prewired 433MHz RF Receiver — labeled/tagged wires ready to land on your Prop Activator's screw terminals (no soldering required)
• 1× 433MHz RF Remote Control (single-button transmitter)
• 1× CR2032 battery (US orders only — international orders ship without battery per shipping regulations; replacement CR2032 widely available at any pharmacy or hardware store)
• Pairing instructions with QR code to video tutorial

How It Wires In

The receiver ships prewired with three labeled/tagged wires. You loosen the screw terminals on your Prop Activator Controller, land each tagged wire on its matching terminal, and tighten. No soldering, no cutting, no crimping — takes about 5 minutes with a small Phillips screwdriver.

How Pairing Works

Pairing takes about 30 seconds:

1. Power up the Prop Activator with the receiver wired in.
2. Press the button on the receiver — the LED will blink 3 times, then stay steady (pairing mode active).
3. Press the button on the remote — the receiver locks in the remote ID.

Pairing is permanent until cleared — the remote stays paired between sessions, power cycles, and reboots. Full walkthrough in the video tutorial above.

Specs

• Frequency: 433MHz
• Effective range: up to 30+ feet line-of-sight, less through walls/props
• Battery: CR2032 coin cell (included for US orders)
• Multiple remotes supported — pair as many remotes as you want to a single receiver
• Wire termination: tagged/labeled wires, terminates on Prop Activator screw terminals
• Compatible with: Prop Activator Controller only

⚠️ Compatibility Notice

Designed & Built by DmitriyCreations

Receiver prewired, tagged, and tested in Los Angeles, California 🇺🇸. Same RF module used in every Actor Helper Controller shipped since 2024 — proven reliable in home haunts and haunted attractions.

Also Check Out

• Prop Activator Controller — the base controller this kit adds RF to
• Scare Actor Helper Controller — comes with a 433MHz remote already included